Filter
Top Products
21
Adding Accessory Handsets
Your phone supports up to eight (8), including any handsets supplied with your phone. Accessory handsets do not
need to be connected to a phone jack. You can now place a fully-featured cordless handset anywhere AC power is
available to connect the handset charger. All the handsets ring when a call is received.
Compatible Handsets
Your phone is compatible with the WDSS 5305. If you purchase an accessory handset, you must register the
handset to the base before use. Accessory handsets will not operate until they are registered.
Charging Accessory Handsets
The handset is powered by a rechargeable battery pack. The battery recharges automatically when the handset is
placed in the charger.
Connect the AC adapter to the DC IN 9V jack and to a 240V AC outlet
that is not controlled by a wall switch.
Caution: Use only the Uniden AAD-600S adapter.
Set the charger on a desk or tabletop, and place the handset in the
charger with the keypad facing forward.
Make sure that the charge LED illuminates. If the LED does not
illuminate, check to see that the AC adapter is plugged in and the
handset makes good contact with the base charging contacts.
Charge the handset battery pack for at least 15-20 hours before using
your new cordless telephone for the rst time.
1)
2)
3)
4)
Route the
cord.
To AC outlet To DC IN 9V
AC adapter (supplied)
Route the
cord.
To AC outlet To DC IN 9V
AC adapter (supplied)