Filter
Top Products
3
Installing the Belt Clip
Line up the tabs with the holes on each
side of the handset. Press the belt clip
down until both tabs click into place.
To remove the belt clip, pull both sides
of the clip to release the tabs from the
holes.
Installing the Optional Headset
Your phone may be used with an
optional headset. To use a headset,
insert the headset plug into the headset
jack. Headsets may be purchased by
calling the Uniden Parts Department.
See back cover page for contact
information.
Charging the Accessory Handset
The handset is powered by a rechargeable battery pack that
automatically recharges when the handset is placed in the
charger.
1. Connect the AC
adapter to the
DC IN
9V
jack and to a
120V AC outlet that
is not controlled by a
wall switch.
Caution: Use only
the Uniden AD-0005
adapter.
2. Set the charger on a
desk or tabletop, and
place the handset in
the charger with the keypad facing forward.
3. Make sure that the
charge
LED illuminates. If the LED does not
illuminate, check to see that the AC adapter is plugged in and
the handset makes good contact with the charging contacts on
the charging cradle.
4. Charge the handset battery pack for at least 15-20 hours before
using your new handset for the first time.