Filter
Top Products
13
TO OPERATE UH075 IN DUPLEX MODE
Eg. CH01 is being used in your area for repeater use.
Press momentarily. The
DUP icon appears.
Press again to deactivate the duplex operation.
UH075 will return to simplex operation.
dup
dup
SCANNING
The UH075 has two types of scanning; Open Scanning (OS) and Group
Scanning (GS).
Scanning allows you to search for active channels
programmed in the OS or GS memory.
To initiate scanning;
1. Assuming the unit is on CH17 when switched on.
2. Press and scanning starts. Scan icon flashes during scanning.
scan
Open Scan (OS) Mode (the absence of GS icon indicates that the unit is on
OS mode)
Allows continuous scanning of channels stored in the Open Scan (OS) memory.
If an active channel is found, scanning will stop on that channel.
The factory has preprogrammed all the 40 UHF channels into the
Open Scan channel memory. However, you can change or
customize the channels by following the steps on programming
Scan Channels on page 15.
Example: CH40 becomes active
If the received signal cease, the unit will wait for at least 3 seconds for the
signal to return, otherwise scanning resumes.
To skip the active channel, press momentarily. Scanning resumes.
To deactivate SCAN, press or .
PTT
scan
mem
Check with your local retailer for available repeaters.
UT01913ZZ_1 11/21/03 5:50 PM Page 13