Filter
Top Products
Programming Scan Channels
1. Select which Scanning Mode you wish
to use on the channel
OS or GS Mode
Note: OS is indicated by the absence of
the GS icon
2. Select the channel you want to store
by pressing [▲] or [▼]
3. Press and hold
[MEM] for 1.5 secs. to
store. MEM icon appears and a short
tone beep is heard.
4. To remove the channel from Memory,
press and hold
[MEM] for 1.5 secs.
once more. Two successive beeps are
heard and the MEM icon disappears.
PRIORITY CHANNEL
The Priority Channel feature allows user to monitor one of 40 channels
in the UH-052XR, monitoring it every 1.5secs during Group Scanning.
Choosing a Priority Channel
The starting channel, when Group Scanning is initiated, is always the
Priority Channel. To change the priority channel setting while scanning,
(eg. PRI Channel is CH17 (476.825 MHz))
a. press [▲], to select a higher channel
(scanning pauses)
or
b. press [▼], to select a lower channel
DROP-OUT DELAY
While scanning, the UH-052XR stops at a busy channel and receives a
transmission. When the received signal is over, the unit will wait for 3
seconds for the return of the signal, otherwise, the radio resumes scanning.
ADVANCED FEATURES
➤ Continuous Tone Coded Squelch System (CTCSS) is a feature
that allows a group to talk to each other without hearing other users
on the same channel.
NOTE : Uniden discourages the use of CTCSS feature until the Australian
Communications Authority (ACA) grants the use of CTCSS on CB
frequencies.
CTCSS
BCL VOX
CTCSS
OS/GS
LOCKDUP
CTCSS
BCL VOX
CTCSS
OS/GS
LOCKDUP
12