Filter
Top Products
[54] ADDITIONAL INFORMATION
www.uniden.com
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and
the base unit. Normally, setting the code is not necessary. In the rare situation that
you suspect another cordless telephone is using the same security code, you can
change the code. To change the digital security code:
1. De-register all the handsets you have (see “De-register the handset“ on page 28).
2. Register the handsets by following step 2-3 in “Registering the handset“ on page
15.
Find Handset
To locate the handset, press find handset on the base when the phone is in
standby mode. All registered handsets beep for 60 seconds, and
Paging
appears on
the handset display. To cancel paging, press any key on the handset or find
handset on the base.
Installing the Beltclip
To attach the beltclip
Insert the beltclip into the holes on each side of the
handset. Press down until it clicks.
To remove the beltclip
Pull either side of the beltclip to release the tabs from
the holes.
If the battery pack is
completely drained, the
handset will not beep
when paging.
note
ADDITIONAL
INFORMATION
TRU8860_1st.book 54 ページ ２００４年１月６日 火曜日 午後６時４０分