Filter
Top Products
GETTING STARTED [27]
www.uniden.com
Setting the Dial Mode
Sets the dial mode to tone or pulse. Most phone systems use tone dialing; the
default setting is tone dialing. Set the dialing mode to match the dialing system
used by your local phone service.
• If you are not sure of your dialing system, set the unit to tone dialing. Make a trial call. If
the call connects, leave the setting as is; otherwise set the unit to pulse dialing.
• If your phone system requires pulse dialing and you need to send DTMF tones in certain
situations during a call, you can switch over to tone dialing (refer to “Tone Dialing Switch-
over” on page 34).
1) Press the MENU soft key. Select the Global Setup
menu, and then the Dial Mode submenu.
2) Press /vol/
∧ or /vol/∨ to select
Tone
or
Pulse
(the initial setting is Tone).
3) Press the OK soft key. You will hear a confirmation
tone.
Setting Voice Mail Tone
Voice Mail Tone sets the voice mail tone. If your service does not support SDT
message signal, set your VMWI (Visual Message Waiting Inculcator) not to detect
SDT message signal.
1) Press MENU soft key. Select the Global Setup menu, and then the Voice Mail Tone
Submenu.
2) Press /vol/
∧ or /vol/∨ to set the voice message
indication (SDT message signal) to On or Off.
3) Press the OK soft key. You will hear a confirmation
tone.
&KCN/QFG
6QPG
2WNUG
$#%- &'.'6' 1-
8QKEG/CKN6QPG
1P
1HH
$#%- &'.'6' 1-
GETTING STARTED
TRU8860_1st.book 27 ページ ２００４年１月６日 火曜日 午後６時４０分