Filter
Top Products
45
Operating the Answering System While You Are Away from Home
You can access your answering system while you are away from home to check, play, and delete messages, or even
record a new greeting message or turn your answering system on and off.
Note:
The answering machine will only playback messages for four minutes and then it returns to the command waiting
mode. To continue playing your messages, press
[0] then [2] again within 15 seconds.
If you enter an incorrect security code three times, you will hear a beep and the answering machine will return to
standby.
To operate from a remote location, use any touch-tone telephone, and follow these steps:
Call your telephone number and wait for the system to answer. If the answering system is off, it will answer after
about 10 rings and sounds a series of beeps.
During the greeting or the beeps (if answering system is off), press
[0] and enter your security code/PIN within
two seconds (see Setting a Security Code or Personal Identication Number (PIN) on page 41).
The answering system announces the current time and the number of messages stored in memory.
You hear “To play incoming messages, press zero-two. For help, press one-zero” followed by a beep.
Enter a remote command from the chart below. You have 15 seconds to enter the rst command; after the rst
command, you have two seconds to enter each command.
•
•
1)
2)
3)
4)