Filter
Top Products
GETTING STARTED [ 9]
INSTALLING AND
ADJUSTING
GETTING STARTED
C. Connect the base unit
1) Connect the AC adapter to the DC IN 9V
jack to a standard 120V AC wall outlet.
2) Set the base and charger on a desk or
tabletop, and place the handset in the
base unit as shown.
3) Make sure that the
charge LED lights up. If the LED does
not light up, check to see that the AC adapter is plugged
in and that the handset makes good contact with the base
charging contacts.
Place the power cord so
that it does not create
a trip hazard or where
it could become chafed
and create a fire or
electrical hazard.
• Use only the supplied AD-490 AC adapter. Do not use any other AC adapter.
• Connect the AC adapter to a continuous power supply.
• Place the base unit close to the AC outlet so that you can unplug the AC
adapter easily.
• After installing the battery pack in the handset, charge your handset at
least
12-15 hours before plugging into the phone line. Once the
handset battery pack is fully charged, connect the telephone line cord to
the base and telephone wall outlet.
4) Connect the telephone line cord to the
TEL LINE jack and
to a telephone outlet once the handset is fully charged.
If your telephone outlet isn't
modular type, contact your
telephone company for assistance.
Modular
DCT4960-2 OM_ENG 9/18/01 4:25 PM Page 9