Filter
Top Products
GETTING STARTED [ 7]
GETTING STARTED
B. Install the battery pack
Charge the battery pack for at least 12-15 hours before
plugging the phone line into your phone.
1) Press down on the battery cover release and slide the
cover down until it comes off.
2) Connect the battery pack connector observing the correct
polarity (black and red wires) to the jack inside the
battery compartment.
Do not exert any force on this connection. It could cause
damage to the battery or to the handset. The plastic
connectors will fit together in only one way.
Once you are certain that you have made a good
connection, then insert the battery pack into the battery
compartment. Do not pinch the wires.
3) Securely close the battery compartment cover by sliding
it up until it snaps into place.
4) Place the handset in the charging cradle.
When the battery is charged, the LCD will display
“
Initializing...” for 5 to 10 seconds.
• Use only the Uniden
battery (BP-490)
supplied with your
phone. Replacement
batteries are also
available through the
Uniden Parts
Department.
(See page 5.)
• Additional handsets
will include their own
individual charging
cradles. The battery
will fully charge after
approximately 12 to
15 hours.
DCT4960-2 OM_ENG 9/18/01 4:25 PM Page 7