Filter
Top Products
FP107 OPERATION
Playing Messages
The FP107's message window shows the total number of messages, both old and new.
If there are new messages, the new message LED flashes.
To play all messages, press .
To adjust the FP107’s volume, slide the speaker volume min/max on the right side
of the phone.
To play only new messages, hold down for 2 seconds.
To replay a message while you are listening to it, press . The current message
replays from the beginning.
To select another message, press or until the desired message number
appears in the display.
To pause while listening to messages, press . PAUSE is displayed. To resume
playback, press again within 60 seconds.
To stop playback, press . The FP107 beeps, says “End of messages” and END
OF MESSAGES is displayed. The FP107 then resets to answer calls.
Deleting Messages
To delete a specific message, press while the message is playing.
To delete all messages, stop playback and hold down until dEL ALL appears,
then press .
The TAD does not delete new messages.
Screening Calls
To screen calls, let the FP107 answer them. TAD IN USE is displayed.
Listen to the caller's message through the FP107's speaker. To adjust the volume, slide
speaker volume - min / max on the right side of the FP107.
If you decide to answer the call, pick up any phone on the same phone line as the
FP107. The FP107 stops recording and resets to answer the next call.
If you do not want to take the call, let the FP107 finish recording the caller's message.
delete
delete
If you answer the phone
just as the TAD answers,
the TAD may not stop
playing the outgoing
message. If this occurs,
simply press .
NOTE
stop
stop
play
play
play
play
19