Filter
Top Products
GETTING STARTED[ 16 ] www.uniden.com
Make sure your battery
pack is fully charged
before choosing the
dialing mode.
1) When the phone is in the standby mode, press and hold
cid/menu. The Caller ID setting screen appears.
2) Press the
vol/ring/ key twice to select ¨Area Code¨.
3) Press
select.
4) Use the number keys (
0 - 9), or delete/ch to enter
the 3-digit area code.
5) Press
select. A confirmation tone sounds and the displayed area code is entered.
6) Press
end or return the handset to the base unit to complete the setting.
The handset returns to the standby mode.
When the area code has already been stored in memory, the
stored area code will be displayed. To change it, use the
delete/ch and number keys to enter the new area code.
Then press select. A confirmation tone sounds. To complete
the setting, press end or return the handset to the base unit.
Choosing the dialing mode
Most phone systems use tone dialing which sends DTMF tones through the phone
lines. However some phone systems still use pulse dialing such as in rural areas.
The default setting is tone dialing. Depending on your dialing system, set the mode
as follows: