Filter
Top Products
46
Remote access away from home
You can operate your answering system from a remote location
using any touch-tone telephone. Use this function to check for
recorded messages, to play or delete messages, even to record a
new greeting, and to monitor sounds in the room.
1 Call your telephone number.
2 While the answering machine is activated, press
#
and your
PIN code.
3 The answering system announces the time and day stamp
and the number of messages stored in memory. Then the
message playback automatically begins.
4 You may continue to listen to your message, or you may
select a command from the following chart.
Command Function
(Press a number within
2 seconds after #)
#
then
1
Repeat a message
#
then
2
Playing your messages
#
then
3
Skipping a message
#
then
4
Deleting a message
#
then
5
Stop message playback
#
then
6
Answering system on
#
then
7
Voice memo record/stop
#
then
8
Greeting record/stop
#
then
9
Answer system off
#
then Room monitor
5 After all of your messages have played, or the playback time
exceeds 4 minutes, you will hear that the intermittent beeps
indicating that the system is in the command waiting mode.
You may enter another command at this time from the chart
above.
6 When you finish, hang up to exit the system.
The answering system automatically returns to standby.
*
Enter a next command
within 15 seconds, or the
answering system
automatically hangs up
and returns to standby.
The system will only
playback messages for
four minutes. To continue
playing your message,
press
#
then
2
again
within 15 seconds.
EXR 2480 H1 99.8.20 3:44 PM Page 50