Filter
Top Products
4
Installing the Battery
Follow the steps below to install the
rechargeable battery pack.
1. Usingthengerindentation,pressin
on the battery case cover and slide it
down to remove it.
2. Plug the battery connector into the
battery compartment jack. Be sure
to match the red and black wires to
the label near the jack.
3. Gently pull on the battery wires. If
the battery connector comes loose,
try connecting it again.
4. Replace the battery case cover and
slide it up until it clicks into place.
Note: Use only the Uniden BT-446 rechargeable battery
pack supplied with your cordless telephone.
Installing the Belt Clip
Line up the tabs with the holes on each side
of the handset. Press the belt clip down until
both tabs click into place.
To remove the belt clip, pull both sides of the
clip to release the tabs from the holes.
Installing the Optional
Headset
Your phone may be used with an optional
headset. To use a headset, insert the
headset plug into the headset jack.
Headsets may be purchased by calling the
Uniden Parts Department. See back cover
page for contact information.