Filter
Top Products
49
Resetting the Handset Without the Base
If your original base is not available for some reason, you can still reset the handset and use it with another base.
Press and hold
[ ] and [#] for at least ve seconds.
Move the cursor to select BASEUNAVAILABLE and then press
[Menu/Select]. BASE UNAVAILABLE appears.
Select the base which you want to de-register from, and then press
[Menu/Select].
Move the cursor to select YES, and then press
[Menu/Select]. You hear a conrmation tone, and the handset
deletes its own base information without contacting the base. If the handset was registered to only one base, it
displays HANDSET NOT REGISTERED-PLACE HANDSET ON BASE TO REGISTER. SEE YOUR OWNER'S
MANUAL FOR HELP. If the handset is still registered to another base, it searches for the other base and then
returns to standby.
Register the handset to the new base (see Registering Accessory Handsets on
page 20).
Traveling Out of Range
During a call, if you move your handset too far from your base, noise may increase. If you pass the range limit of the
base, the handset will beep, display OUT OF RANGE, and then go to standby. The base will maintain the connection
for thirty seconds after the handset goes out of range. If you move the handset back within range of the base within
thirty seconds, press
[ /Flash] or [ ] to pick up the call again.
Note: If it is set to automatically select the available base, the handset will begin searching for another base thirty
seconds after going out of range. (see Selecting the Base on page 21).
1)
2)
3)
4)
5)
UC536BV(DECT2080-2) OM.indb 49 3/24/2008 4:54:12 PM