Filter
Top Products
20
Registering Accessory Handsets
If you purchase an accessory handset, you need to register the handset before use. Handset(s) supplied in the box
with the base are pre-registered at the factory. When charged, pre-registered handsets display a handset ID number.
Handsets that have not been registered display:
↔
To register a DCX200 accessory handset:
Charge the handset for 15-20 hours.
Place the handset in the main telephone base cradle to initiate registration. HANDSET REGISTERING will
appear in the LCD.
Wait approximately thirty seconds, REGISTRATION COMPLETE will be displayed to indicate the handset has
been registered to the base and a handset ID will be automatically assigned.
If REGISTRATION FAILED appears in the LCD, please try these steps again.
To register a DWX207 or DCX300 accessory handset:
Charge the handset for 15-20 hours.
Disconnect the base AC adapter.
Press and hold
[nd hs] while you reconnect the adapter until the charge LED starts to blink.
On the handset, press
[Menu/Select]. Select the REGISTER BASE menu. HANDSET REGISTERING will
appear in the display. (After step 3, you have thirty seconds to complete this step 4 before the system returns to
standby.)
When the handset has registered to the base, the LCD will display REGISTRATION COMPLETE then show the
handset ID number.
If REGISTRATION FAILED appears in the LCD, please try these steps again.
Note: If an accessory handset has ever been registered to a base, you must reset the handset before you can
register it to a new base. See Resetting the Handset on
page 48.
1)
2)
3)
1)
2)
3)
4)
5)
UC536BV(DECT2080-2) OM.indb 20 3/24/2008 4:53:57 PM