Filter
Top Products
English - 23
Answering system problems Possible solutions
My outgoing message is
gone.
x
If there was a power failure, re-record your
personal outgoing message.
I can’t hear the base
speaker.
x
Make sure call screening is turned on.
x
Change the base speaker volume.
Messages are incomplete.
x
Increase the
Record Time
.
x
Delete messages (memory may be full).
The system keeps recording
when I answer on an
extension.
x
You may have to change the line mode.
Contact Customer Service for instructions.
Installing a Line Filter or DSL Filter
A telephone line filter or DSL filter prevents services that use the phone line from
causing interference on your phone. To get a line filter, contact your service
provider or look in an electronics store.
Plug the filter into the telephone wall jack and plug the base into the filter. Make a
test call to make sure the noise is gone.
Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adapter and
phone cord from the wall before touching it.
If the liquid is only on the exterior housing of the base or handset, wipe it off and
use as normal. If you can hear liquid inside the housing:
1. Disconnect all cables and cords and remove all compartment covers.
2. If liquid is leaking from any vent or hole, turn the phone so that vent faces
down. If not, place the largest vent face down.
3. Let dry for at least 3 days. Check for liquid inside the phone before replacing
compartment covers and reconnecting cords.
Resetting a Handset
If you have trouble with a handset or if you want to replace one, reset it:
1. Press and hold
END/CLEAR
and
POUND (#)
at the same time until
System Reset
displays (about 5 seconds).
2. If you still have the base the handset is registered to, select
Deregister HS
, then
select the handset you want to reset. If you don't have that base anymore,
select
Base Unavailable
.
3. To confirm, select
Yes
. The handset displays
Handset not registered
.
Registering a Handset
If you see a “not registered” message on a handset, you must register it to a base
before using it.