Filter
Top Products
16 - English
x Increase the separation between the
equipment and receiver.
x Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
x Consult the dealer or an experienced radio/
TV technician for help.
RF Exposure Informaon
This product complies with FCC radiation
exposure limits under the following
conditions:
x The base must be placed to allow a
minimum of 20 cm (8 inches) between the
antenna and all persons during normal
operation.
x The base must not be collocated or operated
in conjunction with any other antenna or
transmitter.
x The handset is designed for body-worn
operation and meets FCC RF exposure
guidelines when used with any belt clip,
carrying case, or other accessory supplied
with this product. (All necessary accessories
are included in the package; any additional
or optional accessories are not required
for compliance with the guidelines.) Third
party accessories (unless approved by the
manufacturer) should be avoided as these
might not comply with FCC RF exposure
guidelines.
Disable All Funcons Except
Charging
D1481/D1483 Base
1. Press and hold
skIp
and
VoL +
simultaneously, then plug in the AC
adapter.
2. Continue to hold the keys for about 5
seconds. When the message counter
turns off, all functions are disabled
except for charging.
D1481/D1483 Handset
1. Install the battery.
2. When the “Welcome, please wait...”
message disappears from the display,
press and hold
ENd
,
MENu
, and
*
simultaneously.
3. After about 5 seconds, a confirmation
tone sounds, indication all functions
except charging are disabled.
To return to normal operation, cycle
the power for the base and remove and
reinstall the handset battery.
Industry Canada (I.C.) Noce
Terminal equipment
NOTICE: This equipment meets the
applicable Industry Canada Terminal
Equipment Technical Specifications. This
is confirmed by the registration number.
The abbreviation IC before the registration
number signifies that registration was
performed based on a Declaration of
Conformity indicating that Industry Canada
technical specifications were met. It does
not imply that Industry Canada approved
the equipment.
NOTICE: The Ringer Equivalence Number
(REN) for this terminal equipment is
marked on the equipment itself. The REN
assigned to each terminal equipment
provides an indication of the maximum
number of terminals allowed to be
connected to a telephone interface. The
termination on an interface may consist of
any combination of devices subject only to
the requirement that the sum of the Ringer
Equivalence Numbers of all the devices
does not exceed 5.
Radio equipment
The term IC before the radio certification
number only signifies that Industry Canada
technical specifications were met. Operation
is subject to the following two conditions:
(1) this device may not cause interference,
and (2) this device must accept any
interference, including interference that may
cause undesired operation of the device.
"Privacy of communications may not be
ensured when using this telephone."
Warranty (1 Year, Limited)
Evidence of original purchase is required
for warranty service.
WARRANTOR: UNIDEN AMERICA
CORPORATION ("Uniden")