Filter
Top Products
Charging Spare Battery Packs
The Charger Unit of your ANA 9710 is equipped to charge the
Spare Battery Pack with or without the Handset in the front slot.
1. Slide the Spare Battery Pack into the second slot in the
Charging Unit until the retaining clip snaps over the top of the
pack.
2. Make sure the BATT
CHARGE indicator lights. If
the BATT CHARGE indicator
doesn’t light, check to see that
the AC Adapter is plugged in,
and that the Battery Pack is
making good contact with the
Charging Unit charging
contacts.
Note: Charge the Battery Pack without interruption for 12-15
hours.
3. When charging is complete, press out on the latch and remove
the Battery Pack for use. Or, if you don’t need the Battery
pack immediately, leave it in the Charging Compartment; it will
not overcharge.
Low Battery Indicator
When the Battery Pack in the
Handset is low and needs to be
charged, you will see a
message on the display.
On a Call In Standby Mode
All keys and functions are available. None of the buttons operate.
Handset beeps once every 3 seconds Handset beeps every 15 seconds for 3
minutes.
Complete your call as quickly as
possible
Cannot make or receive a call.
Replace Battery pack within 20
seconds to continue call.
Replace Battery Pack before making a
call.
Return the Handset to the Charging Unit for charging or replace the
Handset Battery Pack with another charged Battery Pack.
20