Filter
Top Products
BASIC OPERATION
BASIC OPERATION
FAST PLAYBACK
During message playback, press and keep holding , the
message playback speed increases. This lets you quickly scan a
message or move to any place within a message. To resume to
normal playback, release .
To stop playback at any time, press the .
The DTAM beeps and resets to answer calls.
DELETING MESSAGES
To delete a specific message, press
delete once while the
message is playing. The DTAM beeps once and deletes the
current message, then plays the next.
To delete all messages, hold down delete when playback has
finished. appears, the DTAM announces "Erase
message(s)", then sounds a long beep.
29
BASIC OPERATION
To replay a message while you are listening to it, press .
The current message starts again from the beginning.
To return to the previous message during playback, press and hold
down The previous recorded message plays.
To skip to the next message during playback, press once.
The next recorded message plays.
PAUSE MESSAGE PLAYBACK
To pause while listening to messages, press (pause)
appears on the display. To resume playback, press again
within 60 seconds. Otherwise, the DTAM beeps once, stops
playback, announces "End of message(s)" and displays the total
number of messages.
BASIC OPERATION
28
NOTE:
The DTAM does not delete messages that have not been played to the
end. If you have messages that have not been played, the DTAM
sounds four beeps.
3653 Uniden 7100A Booklet 27/7/98 1:09 PM Page 28