Uniden 7100A Telephone User Manual


 
19
PREPARATION
PREPARATION
18
SETTING THE DAY AND TIME
The DTAM records the day and time of the call with each phone message.
Follow these steps to set the current day and time.
1. Hold down
time set . (clock)
displays briefly then
(the day of the week) appears
on the display, the DTAM
announces "Sunday".
2. To change the day of the week, repeatedly press to
move forward or to move backward until the DTAM
announces the desired day of the week.
3. Press
time set The DTAM announces the preset hour.
4. To change the hour, repeatedly press to move
forward or to move backward to the desired hour.
5. Press
time set The DTAM announces the preset minute.
6. To change the minutes, hold down to move
forward or to move backward to the desired minute.
7. Press
time set to confirm the settings, appears.
The DTAM announces the day and time then beeps. disappears.
To check the current day/time at any time, press
time set
NOTE:
Adjust Volume Slider on the right side of the DTAM to the
desired listening level.
If you do not complete each step within 8 seconds, the
DTAM sounds four beeps, you must then start again from Step 1.
To avoid having to reset the time if AC power is lost, we
recommend you install a backup battery before you set the
day and time.
3653 Uniden 7100A Booklet 27/7/98 1:09 PM Page 18