Uniden 200 Two-Way Radio User Manual


 
E-7
Charging Ni-MH Batteries
Your radio is powered by 6 AAA rechargeable Ni-MH (included) or
6 AAA non-rechargeable alkaline batteries (not included). Before
operating your radio, charge the Ni-MH batteries for 14 hours without
interruption using the multifunction jack (Ext. Speaker/Mic/CHARGE)
on top of the radio located under the rubber protective cap.
Make sure the battery switch is set to Ni-MH (see page 6 ). Also make
sure Ni-MH batteries are installed in your radio matching the polarity
(+ and -) as indicated on the battery compartment. Make sure your
radio is turned off. See note below.
1. Lift up the multifunction jack cover.
2. Plug one end of the AC adapter into
the wall outlet and the other end
into the multifunction jack.
3. Charge the batteries for 14 hours.
NOTE
Radio operation suspends while the unit charges.
The charger won’t overcharge the batteries.
Fully seat the rubber cap after charging.
Be sure to turn your radio off before charging.
Battery Level Display
The battery indicator at the left of the LCD screen indicates the
battery level (0 to 5) at all times.
When the battery level is at Level 0, the
battery indicator flashes and the battery
alert sounds every 5 seconds.
The radio shuts off 60 seconds after the
alert prior to shutdown.
NOTE
In the event that the radio shuts down, turn the power off
before recharging to ensure the radio charges and provides
the correct battery level display indication when turned on.
Lift Up Protective Cap
Note: Waterproofing is not guaranteed
when the cap is open and during
charging.
HIGH
US