Filter
Top Products
Integration Features
Call Record (LVMU only)
Strata LVMU/GVMU Voice Processing System User Guide 7/06 71
2.b. Enter the mailbox number (usually the extension number). Finish by pressing
#. The Record LED flashes rapidly and there is approximately a one second
interval before the recording starts and the Record LED changes to the in-use
interval flash rate. You are now recording.
3. To stop recording, press Record. The LED turns off and the recording stops. To
resume recording at this point you must begin a new recording. See step 1.
Pause/Resume Recording
You can pause the recording while continuing the conversation by pressing Pause key.
The Pause LED flashes red. Your conversation is no longer being recorded.
To resume recording as part of the same message, press the Pause button again. You
can pause and resume indefinitely throughout the conversation. The only limit may be
a message length imposed by the voice mail system
Call Monitor (LVMU only)
Note This feature requires the presence of a Call Monitor feature key to be
programmed on your Strata telephone. Feature code can be used to log out.
To active call monitor login by pressing the Call Monitor Key and entering your
password.
Press "Call Monitor Key" + Password + #.
Following a successful login the Call Monitor LED light will be on.
When a caller enters the user's mailbox to leave a message Call Monitor LED flashes
slowly
• Single press allows user to listen to caller leaving message (one way monitor
only).
Call Monitor LED flashes rapidly. Ending the monitor by hanging up does not
disconnect the caller. Attempting to put the call on hold will end monitoring.
• Second press connects caller to the user (two way speech).
The caller is given no warning when they are connected.
Hanging up now will disconnect the caller.