Toshiba DKT2001 Telephone User Manual


 
Advanced Operation
Automatic Callback
18 Strata CTX DKT3001/2001 Digital Single Line Telephone 01/02
Automatic Callback
When you reach a busy station, you can set Automatic Callback to have the system
monitor the busy extension and notify you when it becomes idle. Automatic Callback
can also place you in queue for an available outside line, if you reach a line group in
which all lines are busy. When a station or line becomes available, the system rings
your telephone. Then when you answer, it automatically rings the intended
destination. The amount of time the system will wait for an idle destination is set in
system programming.
Automatic Callback is also known as CO Line Queuing.
To set Automatic Callback
1. If you hear busy tone after dialing an outside line access code or a station number,
press
. Busy tone stops, followed by success tone, then busy tone resumes.
2. Hang up. You can make other calls while waiting.
3. When the called station or outside line becomes idle, your telephone rings with a
fast LED.
DKT2001: The LED does not work.
If you called a busy station, the extension LED flashes green (incoming call)
and the called number displays.
If you called a busy outside line, the extension LED flashes green (incoming
call rate). The seized lines number displays.
4. Answer within about three rings (5 to 180 secs., set in programming) to prevent the
callback from being cancelled. After you answer, you hear success tone, and the
LED flashes (in-use).
If you hear a busy tone after answering a callback, the called party is already on
another call or the line has already been seized or has received an incoming call.
Your request is not cancelled. You will be called again the next time a line becomes
idle.
If you were attempting to make an outside call, the telephone number is
automatically dialed, including the account code or override codes that were used.
To cancel ACB
Dial .