Filter
Top Products
- Select SECURITY by using the UP- and DOWN keys.
- Press OK to confirm.
- Select EMERGENCY by using the UP- and DOWN keys.
- Press OK to confirm.
- Select the 3e number by using the UP- and DOWN keys.
- Select EDIT
- Edit or enter the telephone number by means of the numerical keypad (press C to erase a digit)
- Press OK to confirm.
- Press ESC to leave the menu.
8.8. External call On/Off
When you transfer an external call to another external number you will have to pay the call cost until
the end of the call between both external parties, therefor it is possible to de-active the external call
transfer so it can’t be used:
- Press MENU when the unit is in standby mode..
- Select BASE SETTING by using the UP- and DOWN keys.
- Press OK to confirm
- Enter the Base Pin code BS_PIN?:
- Press OK to confirm.
- Select PREFIX/ECT by using the UP- and DOWN keys.
- Press OK to confirm.
- Select ECT by using the UP- and DOWN keys.
- Press OK to switch between activate (✔ appears on the display)/deactivate ( - ).
- Press ESC to leave the setting.
8.9. Reset Base
The default settings are:
Subscribed handsets: 0 (none)
Display language : English
Base Pin: 0000
Emergency numbers: 110-112 -empty
MSN list: Empty
Call restriction: Off
Call filter: Off
Prefix: National 0, International 00
Call transfer: ECT (external via network) active
To reset the base to its standard settings:
- Press MENU when the unit is in standby mode..
- Select BASE SETTING by using the UP- and DOWN keys.
- Press OK to confirm
- Enter the Base Pin code BS_PIN?:
- Press OK to confirm.
- Select DEFAULT SET. by using the UP- and DOWN keys.
- Press OK to confirm.
- The display shows SURE?
- Press OK to confirm or ESC to leave the setting.
8.10. Calling Charge information.
This function only works if your ISDN network supports AOC (advice of charge) or your PBX supports
the described service. The charge is expressed in units or in currency depending on the ISDN network.
ENGLISH
89
Butler 5070