Filter
Top Products
To reset the base to its standard settings :
- Press MENU when the unit is in standby mode. .
- Select BASE SETTING by using the UP and DOWN keys.
- Press OK to confirm
- Select ACCESS by using the UP and DOWN keys.
- Press OK to confirm.
- Select RESET by using the UP and DOWN keys.
- Press OK to confirm.
- The display shows RESET?
- Press OK to confirm or ESC to leave the setting.
- Enter the BS-Pin code
- Press OK to confirm.
6.5. Remove Handset
With this function you can remove a handset from the base station. Consequently, the handset cannot
be used on this system and must be re-subscribed.
- Press MENU when the unit is in standby mode. .
- Select BASE SETTING by using the UP and DOWN keys.
- Press OK to confirm
- Select SETUP by using the UP and DOWN keys.
- Press OK to confirm.
- Select DEL. ACCESS by using the UP and DOWN keys.
- Press OK to confirm.
- Select the desired handset by using the UP and DOWN keys.
- Press OK to confirm.
- Enter the Base Pin code BS_PIN:?
- Press OK to confirm.
- Press ESC to leave the setting.
6.6. Change Base PIN Code
The standard Pin code is 0000.
To change the Pin code :
- Press MENU when the unit is in standby mode. .
- Select BASE SETTING by using the UP and DOWN keys.
- Press OK to confirm.
- Select SETUP by using the UP and DOWN keys.
- Press OK to confirm.
- Select BS-PIN by using the UP and DOWN keys.
- Press OK to confirm.
- Enter the Base Pin code (Standard 0000) BS_PIN:
- Enter the new Pin code.
- Re-enter the new Pin code ( ---- ---- ).
- Press OK to confirm.
- Press ESC to leave the menu.
6.7. Dial Mode (Tone/Pulse) and Recall (Flash) Time (100/600ms)
The factory default is:
Dial Mode: Tone (MFV)
Flash Time: Short (100ms)
ENGLISH
61
Butler 5020
Handl. B5020 euro 18/3/02 12:11 pm Page 61