Filter
Top Products
ENGLISH
47
Butler 5020
1. GENERAL
The Butler 5020 is a DECT telephone to be connected to an analogue telephone line.
You can subscribe up to 5 handsets on one base station and every handset can be subscribed on 5
different base stations.
Also handsets of other brands can be subscribed to the Butler 5020 base station, as long as they
support the GAP standard. Important note: not all the functions of the Butler 5020 can be used
if you use a handset other then Butler 5020C.
2. INSTALLATION
2.1. Charger
Before you use the telephone for the first time, you must make sure the batteries are charged for 20
hours. If you don’t do this, the telephone will not function properly.
Installation of the charger:
- Plug one end of the adapter into a power outlet and the other end into the adapter jack on the side
of the charger.
2.2. Batteries in handset
- Open the battery compartment (see below).
- Put 3 batteries (AAA) in the battery compartment
- Close the battery compartment.
- Leave the handset on the charger for minimum 20 hours.
Battery indicator:
( ) The battery is fully charged.
( ) The battery is half drained (50%)
( ) The battery is low. When the battery is low, you will hear a warning signal.
The battery symbol will blink if the charge is unknown.
DC POWER
PLUG IN
Handl. B5020 euro 18/3/02 12:11 pm Page 47