Filter
Top Products
Pre-Walk-Thru Check list
Fol low ing the in struc tions fully to this point you have suc cess --
fully com pleted the fol low ing check list:
r
Lo cated the base sta tion prop erly.
r
Con nected power to base sta tion.
r
Con nected the 1/2-wave an ten nas to the base sta tion.
Checked fre quency range of the an ten nas with the fre -
quency of the base sta tion by cor rectly match ing color
codes.
r
Con nected 1/4-wave an tenna to the beltpack. Checked
fre quency range of the an ten nas with the fre quency of
the beltpack by cor rectly match ing color codes.
r
Base sta tion trans mit power switches in the cor rect po -
si tions.
r
Trans mit mode switch on beltpack set cor rectly
r
Set wired in ter com type cor rectly.
r
Con nected head sets to base sta tions (if needed) and all
beltpacks.
r
Con nected the base sta tion to any aux il iary au dio, in -
ter com, ex ter nal P.A. sys tem, or re lay con tact de tect
cir cuit if needed
r
In stalled bat ter ies in the beltpack.
r
If you missed any of the above in struc tions, go back
and com plete that in struc tion be fore go ing on.
6-1
Section
6