Filter
Top Products
2) Use and store the phone only in normal temperature environments. Extreme
temperatures can shorten the life of electronic devices and distort or melt plastic
parts.
3) Keep the phone away from dust and dirt, which can cause premature wear of
parts.
4) Handle the phone gently and carefully. Dropping it can damage internal circuit
boards or external parts, and can cause the phone to work improperly.
Modifying or tampering with the phone’s internal components can cause a malfunc-
tion. If your phone is not performing as it should, see your distributor for assistance.
If the trouble is affecting the telephone lines, the phone company or service provider
may ask you to disconnect the phone until the problem is resolved.
12. REQUIREMENTS OF PART 68- FCC RULES
This device has been granted a registration number by the Federal Communications Commission, under Part
68 rules and regulations for direct connection to the telephone lines. In order to comply with these FCC rules,
the following instructions must be carefully read and applicable portions followed completely:
1. Direct connection to the telephone lines may be made only through the standard modular cord furnished,
to the utility installed jack. No connection may be made to party or coin phone lines. On the bottom of the
phone is a label that contains among other information, the FCC Registration Number and the Ringer
Equivalence number (REN) for this equipment. If requested this information must be provided to the tele-
phone company. The USOC lack for this equipment is RJIIC.
2. The telephone company, under certain circumstances, may temporarily discontinue and make changes in
Facilities and services, which may affect the operation of the users’ equipment. However, the user shall be
given adequate notice in writing to allow the user to maintain uninterrupted service.
3. In certain circumstances, it may be necessary for the Telephone Company to request information from you
concerning the equipment which you have connected to your telephone line. Upon request of the telephone
company, provide the FCC registration number and the ringer equivalence number of the equipment which is
connected to your line; this information will be found on the device.
4. If any of your telephone equipment is not operating properly, you should immediately remove it from the
telephone line. It may cause harm to the telephone network.
5. If the telephone company notes a problem, they may temporarily discontinue service. When practical, they
will notify you in advance of a disconnection. If advance notice is not feasible, the telephone company must:
promptly notify you of such temporary discontinuance; afford the opportunity to correct the condition;
inform you of your rights to bring a complaint to the FCC under their rules.
6. Repairs to the device may be made only by the manufacturer or an authorized service agency. This applies
at any time during and after warranty. If unauthorized repair is performed, registration, connection to the
telephone lines and remainder of warranty period all becomes null and void.
7. This equipment is hearing aid compatible.
8. This telephone must be connected behind a PBX.
13. REQUIREMENTS OF PART 15 - FCC RULES
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction, may cause harmful inter-
ference to radio communications. However, there is not a guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: 1) Move the telephone away from
the receiver. 2) Consult the dealer or an experienced radio/TV technician for help. Any changes made by the
user not approved by the manufacturer can void the user’s authority to operate the telephone.
14. INDUSTRY OF CANADA REQUIREMENTS
NOTICE: The Industry Canada label identifies certified equipment. This certification means that the equip-
ment meets certain telecommunications network protective operational and safety requirements as prescribed
in the appropriate Terminal Equipment Technical Requirements documents. The department does not guar-
antee the equipment will operate to the user satisfaction. Before installing this equipment, users should ensure
that it is permissible to be connected to the facilities of the local Telecommunications Company. The equip-
ment must also be installed using an acceptable method of connection. The customer should be aware that
compliance with the above conditions may not prevent degradation of service in some situations. Repairs to
certified equipment should be coordinated by a representative designated by the supplier. Any repairs or
9