Filter
Top Products
12
5.
ConnecT/R. You can connect it by plugging
it into the TEL DEVICE jack on the
ConnecT/R or by plugging it into the wall
jack that is connected to the TEL DEVICE
jack on the ConnecT/R.
To install two telephone devices on a
ConnecT/R,
use a T-type adapter (AT&T
part # 267A2 or 267A). Plug the adapter into
the TEL DEVICE jack (either directly or
indirectly through a wall jack, as described
above) and plug the telephone devices into
the adapter jack.
Connect the ConnecT/R to the AC power
outlet. Plug the power connector into the
POWER jack on the back of the ConnecT/R.
To prevent the power cord from pulling out
easily, make a small loop of cord near the
power connector and slip it behind the strain
relief tab next to the POWER jack on the
ConnecT/R. Plug the wall transformer into
an AC power outlet that is at least 3 feet
away from the controller and not controlled
by a wall switch. (If it is any closer to the
controller, you may hear a hum on your
SPIRIT
System.)
NOTE: Use only a UL Listed wall plug-in
power transformer that has Class 2
outputs and the following characteristics:
Input rating:
99-127 V AC rms 60 Hz
150 mA maximum
Output rating:
27-35 V DC at 200 mA
14-18 V DC at 200 mA
The power transformer supplied with the
ConnecT/R has these characteristics.
AC
Power Outlet
ConnecT/R