Filter
Top Products
Setting Up Your FM2552/FM2000
When setting the FM2552/FM2000 to receive Caller ID
information, THE HANDSET OF THE UNIT MUST BE IN THE
BASE (ON HOOK).
NOTE: Do not lift the handset until you are finished setting the
Caller ID information.
To Set Language
1. After installing the batteries
and COIL CORD, all LCD
segments will light up and
the display will show:
2. Press the REVIEW " or
" Arrow to select
language. The display will
show:
3. Press the "ERASE" key to
confirm the displayed language. The unit will proceed to the area
code setup.
To Set Area Code
NOTE: In order for the Caller ID Redial feature to work
properly, you must set your local area code.
1. Press " or " Button to enter the correct first digit of your
local area code. Press the "ERASE" Button to move to the next
digit.
2. Repeat step 1 for the
programming of the second
and third digits of your local
area code.
3. Press the "ERASE" key to confirm the set area code. The unit will
proceed to the contrast level setup.
To Set Contrast Level
1. Press the " or " Button
to adjust the display contrast
to a darker or lighter level.
"
"
""
""
9
Setting Up Your FM2552/FM2000
Note: 1. When the low battery indicator is
displayed, disconnect all connections to
your FM2552/FM2000 and replace the
batteries.
2. To set up your FM2552/FM2000 again,
press the Caller ID "REDIAL" Button for
2 seconds in Date/Time screen when the
handset is on the cradle.
3. If you try to use the telephone before finishing the Caller ID set up,
or if you pause more than 40 seconds during any of the above steps,
the display will show "SET LANGUAGE" to remind you to finish
this sequence.
4. When the unit is in the standby mode (i.e. not displaying Caller ID
information), the current time will display in the middle of the screen.
In the situations when the Caller ID information is display, the
current time will be shown in a smaller size on top line.
REDIAL ERASE REVIEW
AM
10
2. Press the "ERASE" key to
confirm the set contrast level.
3. The display will show the
default Time/Date (12:00am
1/01). The time and date will
automatically be updated as
incoming Caller ID calls are
received.