Sony PEG-TJ35 PDAs & Smartphones User Manual


 
44
Sony Personal Entertainment Organizer PEG-TJ35/TJ25 3-087-353-11 (1)
I cannot turn on my CLIÉ handheld
BIs the POWER/HOLD switch of your CLIÉ handheld in HOLD mode (page 61) ?
Your CLIÉ handheld does not work when the POWER/HOLD switch is in HOLD
mode. Make sure you release HOLD mode.
BHas the battery power of your CLIÉ handheld run out?
Connect your CLIÉ handheld to the AC power adapter with the plug adapter, then
allow it to be charged for a few minutes before turning it on. If it turns on, continue
charging for approximately four hours and then perform a soft reset.
BIs the connector between your CLIÉ handheld and the plug adapter dirty?
You cannot charge your CLIÉ handheld if the connector is dirty. Connect and
disconnect your CLIÉ handheld and the plug adapter several times to clean the
connector.
BPerform a soft reset by pressing the RESET button at the back of your CLIÉ handheld
(page 32).
The screen is not displayed even though the POWER
LED is on
BIs the POWER/HOLD switch of your CLIÉ handheld in HOLD mode (page 61) ?
The screen is not displayed when the POWER/HOLD switch is in HOLD mode. Make
sure you release HOLD mode.
BPerform a soft reset by pressing the RESET button at the back of your CLIÉ handheld
(page 32).
My CLIÉ handheld does not respond
BIs the POWER/HOLD switch of your CLIÉ handheld in HOLD mode (page 61) ?
Your CLIÉ handheld does not operate when the POWER/HOLD switch is in HOLD
mode. Make sure you release HOLD mode.
BIs your CLIÉ handheld placed near the IR port of your computer?
Move your CLIÉ handheld away from the IR port of your computer except when
performing the IR HotSync
®
operation, as a malfunction may occur. You can also
disable the IR feature by selecting [Off] next to [Beam Receive:] in [General] of the
Preferences screen.
BPerform a soft reset by pressing the RESET button at the back of your CLIÉ handheld
(page 32).
My CLIÉ handheld does not work properly