Filter
Top Products
21
PJ-NET ORGANIZER
OWNER'S MANUAL [PLV-80/75 Series]
ENGLISH
2 Configuration for IP Address/ Sub net/ Gateway*
1
/DNS*
2
Press SELECT button again. The following network setting pallet appears on the screen.
Enter the specified network addresses.
How to enter the numbers
There are 2 ways to enter the numbers, one is by using the point buttons (d e ) on
the remote control or on the projector, the other is by using the screen 10-key pallet by
which the numbers can be entered directory. For further information see "How to enter
the numbers with the screen 10-key pallet" (+ p.23).
3 Fixing the network configuration
After completing the entering of address, select "SET" and
press SELECT button.
The network unit starts re-booting
and displays message "Please wait..." on the screen until
the re-booting is complete.
Do not disconnect the AC
cord during this period.
Completing of installation
Now the installation is complete. The IP address of this projector is set to "192.168.1.201".
Item Description
IP address .............Sets IP address of the projector
Sub net ...................Sets Subnet mask. Normally sets 255.255.255.0
Gateway*
1
.............Sets IP address of the default gateway (Router)
DNS*
2
.......................Sets IP address of the DNS server. Must be set when using the e-mail function
*1 In the network environments not using a Gateway or Router, the Gateway address should be set to [0.0.0.0].
*2 If you do not use the functions E-mail or DNS server, it is also set [0.0.0.0] for the DNS address.
✐
Refer to the projector's owner's manual for operation of the projector.
Installation and network configuration
The red frame moves
sequentially left or right
with 7 8 button.
The number up or down
with d e button.