Filter
Top Products
14
INITIAL PROGRAMMING
Clear message waiting
1. Press the MENU/OK key.
2. Press
or to select “CLEAR MSG WAIT”.
3. Press
MENU/OK. The screen will show “CONFIRM?”
4. Press
MENU/OK again to confirm or press C repeatedly to return to standby
mode.
BASICS
When you first set your unit up, you may hear a beeping tone and see “OUT OF
SERVICE” on the handset display area. This is normal, and means that the handset
needs to synchronize with the base unit before you can use it. Place the handset on
the charger for a few seconds until “READY” appears on the handset display.
Note: You can assign a name to the handset, When you do this your name will
appear instead of “READY”. For instructions on how to assign a name to a
handset, refer to the
Handset name section on page 11 for more information.
Standby mode
If the handset is synchronized with the base unit and is not “in use” or in
“
programming mode”, “READY” (or a name if entered) will appear on the LCD
display.
Receiving a call
When an incoming call is received the handset will ring, “EXTERNAL CALL” will
show on the display, and the in-use LED on the base unit will flash*. If you are
already on the line, a beep will announce you have a call waiting.
* If you subscribe to a Caller ID service from your phone company, Caller ID
information shows on the display instead of “EXTERNAL CALL”.
1. Press
TALK / any key (0-9) * or # to answer a call.
Note: If the handset is in the base cradle, remove it from the base before
pressing the
TALK key.
If “AUTO ANSWER” is enabled, you can accept an incoming call by simply lifting
the handset off the base. See the
Auto answer section on page 13 for more
information.
2. Press
TALK again to hang up.
Note: If you place the handset back to the base cradle, the handset will
automatically hang up.