Filter
Top Products
20
TROUBLESHOOTING
We do not expect you to have any problems with your TAD-798, but if you do,
try these suggestions.
If the TAD still doesn’t operate properly, try resetting it (see “Resetting the TAD”
on Page 21) or take it to your local RadioShack store for assistance.
Problem Remedy
The incoming message is incom-
plete.
Be sure the memory is not full.
The incoming message is un-
clear.
Be sure
VOLUME
is set to the desired
sound level.
The TAD does not answer after
two, four, or seven rings.
Be sure the TAD is set to answer calls.
Lo
appears on the display. The backup battery is weak. Replace the
battery (see “Installing a Backup Battery”
on Page 7).
The TAD does not respond to the
remote operation security code.
Make sure the phone you used to dial the
TAD is a touch-tone phone, or use a pock-
et tone dialer.
Re-enter your remote operation security
code, pressing each button for 2 seconds.
Make sure the remote operation security
code you entered is correct, or try entering
the default code of 798. The remote oper-
ation security code might have reset to the
default code due to a power failure and
weak backup battery.
43-798.fm Page 20 Monday, August 16, 1999 9:33 AM