Filter
Top Products
16
4. Repeatedly press
SKIP
or
REPEAT
to set the second digit, then press
STOP
. The third digit appears.
5. Repeatedly press
SKIP
or
REPEAT
to set the third digit, then press
STOP
. The TAD sounds a long beep
then announces and displays the
new CBT code.
CHANGING THE REMOTE
OPERATION SECURITY
CODE
The TAD’s remote operation security
code is preset to 798, but you can
change it by following these steps.
Note:
If you do not complete each step
within 8 seconds, the TAD sounds four
beeps and exits setup. Start again from
Step 1.
1. Hold down
CODE
(
Co
appears) until
the TAD beeps once.
2. Press
CODE
again.
Sc
(security
code) and the digits of the current
code appear in sequence, then the
first digit reappears.
For example, if the security code is
798, the message counter shows
Sc
,
–
7
,
–9
,
–
8
, then
–
7
.
3. Repeatedly press
SKIP
or
REPEAT
to set the first digit, then press
STOP
. The second digit appears.
4. Repeatedly press
SKIP
or
REPEAT
to set the second digit, then press
STOP
. The third digit appears.
5. Repeatedly press
SKIP
or
REPEAT
to set the third digit, then press
STOP
. The TAD sounds a long beep
then announces and displays the
new security code.
43-798.fm Page 16 Monday, August 16, 1999 9:33 AM