Filter
Top Products
43
HOT KEYPAD
On your phone system your keyset’s keypad can be made “live”or “hot”so that it is
not necessary to lift the handset or press the SPEAKER button before you begin
dialing. Calls can be made and features activated by simply dialing the C.O. line
number, trunk group access code, intercom number or feature access code.To ac-
tivate this feature:
• With the handset on-hook, press TRANSFER and then dial 110.
• Dial 031 to turn the Hot Keypad on or 030 to turn it off.
• Press TRANSFER to store your selection.
KEY CONFIRMATION TONE
You can hear a short beep (confirmation tone) each time you press a button on the
dial pad.This tone can be turned on or off.
• While on-hook, press TRANSFER and then dial 110.
• Dial 040 to turn tones off or 041 to turn tones on.
• Press TRANSFER to store your selection.
REJOINING A PAGE
This feature allows you to hear the remaining portion of an ongoing internal page
after you return your keyset to idle.To enable this feature:
• With the handset on-hook, press TRANSFER and then dial 110.
• Dial 051 to turn this feature on or 050 to turn it off.
• Press TRANSFER to store your selection.
RING PREFERENCE
This feature automatically answers ringing calls when you lift the handset. This
method will always answer calls in the order they arrived at your keyset.When you
turn ring preference off,you must press the flashing button to answer a call,allow-
ing you to answer calls in the order you choose.
• With the handset on-hook, press TRANSFER and then dial 110.
• Dial 061 to turn ring preference on or 060 to turn it off.
• Press TRANSFER to store your selection.
AUTO ANSWER CO CALLS
This option will allow CO calls that directly ring your phone to auto answer.When
a CO call arrives at your station and this option set for ON your phone will sound
two beeps, the same as when a screened transfer is completed, and you will be
SET ANSWER MODE (INTERCOM)
You can receive internal calls in one of three modes (see Answering Intercom Calls
under Intercom Calls for descriptions):
• While on-hook, press TRANSFER and then dial 103.
• Dial 0 for Ringing,1 for Auto Answer or 2 for Voice Announce.
• Press TRANSFER to store your selection.
SET ANSWER MODE (CO)
Your incoming CO calls can be set to follow the intercom answer mode.
• While on-hook, press TRANSFER and then dial 110
• Dial 15 to access AUTO ANS CO.
• Press the VOLUME UP or DOWN key to change status.
• Press TRANSFER to store your selection.
AUTOMATIC HOLD
While on an outside call, pressing a line button, route button or a flashing CALL
button will automatically put your call on hold and connect you to the next call.
This feature can be turned on or off at your keyset.
• With the handset on-hook, press TRANSFER and then dial 110.
• Dial 001 to turn Automatic Hold on or 000 to turn it off.
• Press TRANSFER to store your selection.
NOTE: Intercom calls can be automatically put on hold by pressing TRANSFER.
HEADSET OPERATION
Keyset users can switch between headset mode and handset mode. When using
headset mode,press the FLASHING CALL button to answer and release calls.
• With the handset on-hook, press TRANSFER and then dial 110.
• Dial 021 to use the headset or 020 to use the handset.
• Press TRANSFER to store your selection.
Your keyset may be equipped with a Headset mode button. If it is so equipped
pressing this button while the light is out will cause the keyset to enter headset
mode and the light will illuminate to indicate this. Pressing the button while the
light is lit will cause the keyset to return to handset mode and the light will go out.
42
Home Page
Table of Contents
ITP-5107S