Filter
Top Products
AME Password
If your keyset has AME PASSWORD (MMC 110) set to YES, you must enter your
station password to listen to messages being left. This will prevent unauthorized
people from listening to messages being left for you.
If the password option is turned on, while a message is being left,press the flash-
ing AME indicator and enter your station password (not your SVMi E-Series pass-
word).You will then hear the message being left.
Call Record
If you have a call record button assigned to your phone, you may press it at any
time, to record the conversation in progress. If you have a display keyset, you will
also have the soft key options to pause and time the message.
81
Note: Remember if you know what digits to press, you can enter them at any
time you do not have to wait to be prompted. This feature can be toggled
on/off at anytime.Also if it is off you will be prompted within each subscriber
menu to press zero for more options.This enables you to still be able to find
out what to do if you were to get lost and extended prompting was disabled.
KEYSET USER FEATURES
The following options are available if you have a display keyset.They require setup
by the System Administrator.
Message Waiting Lights
When new messages are left in your mailbox,the voicemail message light on your
keyset will flash. Press this flashing key [VMMSG] and follow the prompts to
retrieve messages.This key may be pressed at any time to log into your Subscriber
Main Menu.
Answer Machine Emulation
If you have an Answer Machine Emulation key programmed on your keyset, you
can use it to monitor calls going to your voicemail, and optionally answer them.
The operation of this feature is similar to screening a call on a home answering
machine.
Your keyset must be set to forward on no answer to voicemail.After ringing your
station the caller will be connected to your voicemail and hear your personal
greeting before leaving a message. During this time you will be monitoring the
connection between the caller and your voicemail box. At this time you will only
be monitoring the call, you can not talk to the other party until you answer.You
may pick up the call at any time or ignore it.
To activate this feature press the AME button. The associated indicator will be lit
steady. Press again to turn off. If this key is pressed while a station is ringing (dur-
ing forward no answer), the feature will be turned on for the current call only.
While the caller is leaving a message or ringing you may:
■ Press [#] to immediately put the caller in your voice mailbox and monitor it.
■ Press [✱] to immediately disconnect your station. The caller continues to
leave a message normally.
■ Pick up the handset and monitor privately.
■ Press ANS / RLS to answer the call (using the handset or speaker).
80
Home Page
Table of Contents
ITP-5121D