Filter
Top Products
Samsung iDCS500 iDCS Keyset User Guide
–
3
–
SPEAKERPHONE
Pressing the ANS/RLS key will answer or release a call on the speaker-
phone.
Switching from the handset to the speakerphone is easy. Press the Speaker
key and replace the handset.
VOLUME CONTROLS
iDCS series keysets use the Volume up and down (s and t) keys to
adjust the ringer volume while the keyset is ringing, the speaker volume while
the speakerphone is in use and the handset volume while you are listening.
These three levels will be stored in memory until changed. If background
music is turned on at your keyset, the volume keys will also control the level
of music. The volume of pages heard through the speaker can be adjusted
during a page announcement using the Volume keys. (There are eight user-
programmable levels for ring, off-hook ring and handset volume, and 16 levels
for speaker, background music and page volume.)
Note: Volume levels can also be changed by dialling Transfer 114 and selecting
the required option(s).
HOT KEYPAD
Your keyset’s keypad can be made “live” or “hot” so that it is not necessary
to lift the handset or press the Speaker key before you begin dialling. Calls
can be made and features activated by simply dialling the line number, trunk
group access code, internal number or feature access code. Dialling feature
descriptions in this guide assume that the Hot Keypad feature is switched
on. If it is not, always lift the handset or press the Speaker key before dial-
ling. (Refer to the section “Customising Your Keyset” for details on the Hot
Keypad feature.)
KEYSET STATUS INDICATOR
The keyset status indicator lamp is positioned on the top right corner of the
keyset above the display. This status indicator is a tri-coloured lamp (red,
green and amber) that provides greater visibility of your keyset’s status than
the individual key LEDs. The status indicator provides the following indica-
tions:
• Busy/Off Hook: Steady Red
• Internal Ring: Flashing Red