RCA RC940 Telephone User Manual


  Open as PDF
of 24
 
8
Note: The indicator lights on the base and extension units blink green
when the handset connected to the extension unit is taken off its hook.
3.Pickupthehandsetandlistenforadialtone.Ifyouhearone,you've
successfullysetupthebaseandextensionunits.Ifyoudonotheara
dialtone,seetheTroubleshootingsectioninthismanualforpossible
solutions.
Programming Additional Extension Units
Followthesestepstoaddextensionunitstoyourcurrentsetup.
Note: If your first extension unit's indicator light remains red, follow
these steps to get the extension and base units to recognize each other.
1.PressthePROGRAMbuttonontheright
side of the base unit. The indicator on
the front of the base unit begins to flash
orange. The base unit is now in program
mode,whichallowsnewlyaddedextension
units to get the current link code.
NOTES:
• If the base unit's indicator light turns solid
red before it begins to flash orange, you
need to press the PROGRAM button on
all extension units while the base is in
program mode.
• Make sure neither the base nor extension
unit is plugged into a surge protector, plug
strip, or extension cord.
2.PressthePROGRAMbuttonontheright
sideoftheaddedextensionunit(or,
ifyou'renotaddinganextension,the
unitwithasolidredindicatorlight).The
indicatorlightontheextensionunitflashes
red,thenturnssolidgreen.
Ifyouareaddingmorethanoneextension
unit,pressthePROGRAMbuttononeach
addedextensionunit.
 previous next