Filter
Top Products
8
4. Remove the handset from the cradle and set aside. Turn the base over
and align the four slots on the bottom of the base with the four hook-
tabs on the mounting bracket.
5. Insert the hook-tabs into the slots and push upwards until the mounting
bracket snaps securely into place.
6. Plug the telephone line cord into the TEL LINE jack on the back of the
base and into a modular jack.
NOTE: If desired, gather the extra telephone line cord together, fasten with a
wire tie, and store inside the wall mounting bracket.
7. Slip the mounting holes on the bracket over the wall plate posts and
firmly slide the unit down into place (wall plate not included).
8. Place the handset in the cradle.
CAUTION: Use only the ATLINKS USA, Inc. 5-2521 power supply that
came with this unit. Using other power supplies may damage the unit.