Filter
Top Products
21
4. Press mem and
ENTER NAME
shows on the display.
5. Use the handset number pad to enter the name, then press mem and
ENTER TEL NUMBR
shows on the display.
6. Press redial/delete to display the redial number and name.
7. Press mem again to confirm.
Note: If the redial number has more than 24 digits, the redial number cannot
be stored in memory.
To replace an old redial number stored in a memory location with
a new redial number:
1. Repeat steps 1 through 5, then press redial/delete to display the new
redial number and name.
2. Press mem again and the new redial number replaces the old redial
number in that memory location.
DIALING A CALLER ID NUMBER
1. Make sure the phone is OFF (not in TALK mode).
2. Use the CID (up or down arrow) button to display the desired Caller
ID record.
3. Press the TALK/callback button to dial the number.
CHANGING THE NUMBER FORMAT
The FORMAT button lets you change the format of the displayed number.
The available formats are as follows.
7-digit 7-digit telephone number.
10-digit 3-digit area code + 7-digit telephone number.
11-digit long distance code “1” + 3-digit area code + 7-digit
telephone number.
1. Use the CID (arrow) button to scroll to the number you want to call back.
2. If the number will not dial as shown, press the FORMAT button. Repeat
if necessary, until the correct number of digits are shown.
3. Press TALK/callback.
NOTE: If you find it necessary to dial all local calls with the area codes
included, press and release flash/program, until SET AREA CODE is displayed.
Then enter "000." Press flash/program again to confirm.