Filter
Top Products
9
WALL MOUNT INSTALLATION
TWO LINES ON A SINGLE MODULAR JACK
1. Remove the handset hook; turn it
upside down, and put it back in the
slot. You need to do this so the handset
doesn’t fall out of the base.
2. Plug the gray telephone line cord into
the jack marked L1 OR L2 on the back
of the unit and plug the other end into
a dual-line modular wall jack.
3. Reverse the direction of the mounting
bracket and replace it by putting the
tabs into the slots on the top of the
unit first and snapping the bottom tabs
into place.
4. Connect the power supply adapter to
the POWER 9V DC jack on the back of
the unit. Then thread it through the
bottom of base.
5. Slip the mounting holes over the wall
plate posts and slide the unit down
firmly into place. (Wall plate not
included.)
(Installation continued on next page.)
2
3
4
5
PAG E
LINE 1
LINE 2
CHARGE
PAG E
1
CAUTION: Use only the ATLINKS USA power supply 5-
2445(white)/5-2446(black)that is compatible with this unit. Using
other adapters may damage the unit.