Filter
Top Products
19
TAD Operation
To start recording a phone conversation,
hold down
MEMO
on the base until the TAD
beeps and
––
appears. To stop recording,
press
PLAY/STOP
or
MEMO
.
The TAD stores a recorded conversation as
a message (see “Playing Messages”).
Note:
The TAD does not record conversa-
tions less than two seconds long, or that use
the speakerphone.
PLAYING MESSAGES
After the TAD has recorded a message, the
total number of messages stored appears in
the message counter window. If you have
new messages, the message counter flash-
es.
To play your messages, press
PLAY/STOP
.
The TAD announces the number of new and
old messages, then plays the new messag-
es. The message number appears in the
message counter window as each message
plays, and the TAD announces the day and
time of the call at the end of each message.
To play all messages after playing the new
messages, press
PLAY/STOP
again.
To skip to the next message, press
SKIP
dur-
ing playback.
To replay the current message from the be-
ginning, press
REPEAT
. If you press
REPEAT
within about 2 seconds after a message be-
gins playing, the TAD replays the previous
message.
ADJUSTING THE TAD’S
VOLUME
To adjust the speaker’s volume, repeatedly
press
VOLUME
8
88
8
or
9
99
9
on the base. The
volume setting from
1
(lowest) to
10
(high-
est) appears in the message counter win-
dow.
DELETING MESSAGES
To delete the current message while it is
playing, hold down
DELETE
until the TAD
beeps.
To delete all messages at once, while mes-
sages are not playing, hold down
DELETE
on
the base until the TAD beeps and
0
appears
in the message counter window.
Note:
You cannot delete new (unplayed)
messages. If you try to delete all messages
at once while you still have new messages,
the TAD beeps quickly five times and does
not delete any messages.
SETTING THE REMOTE
OPERATION PIN
The TAD’s two-digit remote operation PIN
(personal identification number) prevents un-
authorized remote access to your messages.
The PIN is preset to 80. Follow these steps
to change the PIN to any number from 00 to
99.
Note:
If you wait more than 2 minutes be-
tween each keypress, the TAD exits the PIN
setting process. Start again at Step 1.
1. Hold down
PIN
until the TAD beeps and
00
appears in the message counter win-
dow.
2. Press
SKIP
to set the first digit of the PIN
higher or
REPEAT
to set it lower. Then
press
PIN
.
3. Press
SKIP
or
REPEAT
to set the second
digit of the PIN, then press
PIN
. The TAD
announces the new PIN.
To check your PIN at any time, press
PIN
.
The PIN appears in the message counter
window, and the TAD announces it.
43-1130.fm Page 19 Tuesday, May 30, 2000 1:22 PM