Filter
Top Products
8
2. Repeatedly press
REPEAT
to select
the desired display contrast set-
tings.
Note:
The TAD-704 provides ten
(
0
–
9
) display contrast settings.
3. Press
CALLBACK
to lock in the set-
ting.
4. Press
STOP
to return to the time dis-
play.
SETTING THE LONG
DISTANCE CODE
Note:
If you do not complete each step
within 8 seconds, the TAD exits setup.
Start again at Step 1.
1. Hold down
STOP
until the TAD
beeps once.
2. Press
CALLBACK
once.
1
and
SET
LDS
CODE
appear.
1
flashes.
3. Repeatedly press
REPEAT
to set the
long distance code to
1
,
9
, or
0
.
4. Press
CALLBACK
then press
STOP
to return to the time display.
SETTING THE AREA
CODE
Note:
If you do not complete each step
within 8 seconds, the TAD exits setup.
Start again at Step 1.
1. Hold down
STOP
until the TAD
beeps once.
2. Press
CALLBACK
twice.
000
and
SET
AREA
CODE
appear. The first
0
flashes.
3. Repeatedly press
REPEAT
until the
first digit of your area code appears,
then press
SKIP
to the second digit.
The second
0
flashes.
Note:
If you make a mistake,
repeatedly press
SKIP
until the
desired digit flashes then re-enter
the code.
4. Repeat Step 3 to set the second and
third digits of your area code.
5. Press
CALLBACK
then press
STOP
to return to the time display.
SETTING THE DAY, TIME
AND DATE
To avoid losing the day and time set-
tings if AC power fails, we recommend
you install a backup battery before you
set the day and time (see “Installing a
Backup Battery” on Page 7).
Follow these steps so the TAD can
record the correct day and time each
message and memo is recorded.
Note:
If you do not complete each step
within 8 seconds, the TAD exits setup.
Start again at Step 1.
1. Hold down
STOP
until the TAD
beeps once.
2. Repeatedly press
CALLBACK
until
SUNDAY appears.
43-704.fm Page 8 Wednesday, November 17, 1999 4:47 PM