Filter
Top Products
16
Remote Command List
Press: To:
00
Set the TAD to not answer calls. It beeps and says
“Answer off.”
01
Set the TAD to answer calls. It beeps, says “Answer
on” and plays OGM 1. If no OGM 1 is recorded, it
beeps and says “You have no announcement one.”
02
Set the TAD to announce only. It beeps, says
“Announce only,” and plays OGM 2. If no OGM 2 is
recorded, it beeps and says “You have no announce-
ment two.”
21
Play all messages. If there are no messages, the TAD
says “You have no messages.”
22
Announce all Caller ID records. The TAD announces
the total calls and each caller’s information. If there
are no Caller ID records, the TAD says “You have no
calls.” If the Caller ID record is deleted but its accom-
panied message is not deleted, the TAD says
“deleted” after announcing that Caller ID record's
number.
31
Play new messages. The TAD announces the num-
ber of new messages before playback. If there are no
new messages, the TAD says “You have no new mes-
sages.”
32
Announce new Caller ID information. If there are no
new Caller ID calls, the TAD says “You have no new
calls.” If you get a private call or out of area call, the
TAD says “unknown number” after announcing Caller
ID number and time.
4
Monitor the room for 20 seconds. Press 4 to repeat.
5
, the TAD says “Erase,”
then press
1
Delete all messages (except new messages).
5
, the TAD says “Erase,”
then press
2
Delete all Caller ID calls (except new Caller ID calls).
43-704.fm Page 16 Wednesday, November 17, 1999 4:47 PM