Filter
Top Products
23
If you still have problems, disconnect the phone. If other phones on the same line
work properly, the fault is in this phone or its installation. If you cannot find the prob-
lem, take your phone to your local RadioShack store for assistance.
The phone does not work or works
poorly.
Be sure the base’s phone line cord and
AC adapter are correctly and securely
connected.
The handset battery pack does not
charge.
Check the charging contacts on the
handset and base. If they are dirty, clean
them with a pencil eraser.
The handset does not ring or receive
a page.
Be sure the handset’s ringer is turned on.
Adjust the base’s antenna so it stands
straight up.
Move closer to the base.
Move the base away from noise sources.
The battery pack might be weak. Charge
the battery pack by placing the handset
on the base for 15–24 hours.
Return the handset to the base to reset
the security code.
The handset stops working or works
poorly during a call.
Move the handset closer to the base.
Adjust the base’s antenna so it stands
straight up.
Be sure the handset’s battery pack is
charged. (If the battery power is too low,
it does not have enough power to light
the BATT LOW indicator.)
The caller’s voice gets cut off and is
hard to hear when using the speaker-
phone.
Press
VOLUME
s to turn up the speaker’s
volume.
Press
MUTE
on the handset to turn off the
ET-928’s microphone while the other par-
ty is speaking.
Problem Solution
43-1098.fm Page 23 Tuesday, August 17, 1999 4:03 PM