Filter
Top Products
9
If you need to connect a long modu-
lar cord to the
L2 jack, remove the
short modular cord from the left
groove and route the long modular
cord through the groove on the bot-
tom of the base.
5. Route the end of the short modular
cord through the hole in the center
of the bracket, then insert the tabs
on the narrow end of the bracket into
the upper slots on the base’s bot-
tom.
6. Route the adapter cord and the long
modular cord (if you have connected
it) through each slot on the bottom
of the wide end of the bracket, then
push the tabs on the wide end of the
bracket into the other slots until the
bracket clicks securely into place.
7. Plug the AC adapter into a standard
AC outlet.
8. Plug the short modular cord into the
wall plate jack, then align the base’s
keyhole slots with the wall plate
studs and slide the base downward
to secure it.
If you attached a long modular cord,
plug it into the other phone line jack.
9. Lift the base’s antenna to a vertical
position.
Directly on a Wall
For this mounting method, you need two
screws (not supplied) with heads that fit
into the keyhole slots on the mounting
bracket.
1. At the desired mounting
location, drill two holes
3
15
/
16
inches (100 mm)
apart vertically. Then
thread a screw into each
hole, letting the heads
extend about
3
/
16
inch (5
mm) from the wall.
2. Remove the bracket by holding in
both tabs on the wide end, then gen-
tly pulling out the wide end of the
bracket.
3
/
16
3
15
/
16
43-689.fm Page 9 Thursday, September 16, 1999 10:22 AM