Filter
Top Products
8
5. Insert the tabs on the narrow end of
the bracket into the lower slots on
the base’s bottom, then push the
tabs on the wide end of the bracket
into the other slots until the bracket
clicks securely into place.
6. Plug the AC adapter into a standard
AC outlet.
7. Plug the other end(s) of the modular
cord(s) into the modular telephone
jack(s).
8. Lift the base’s antenna to a vertical
position.
On a Wall Plate
1. Remove the base’s bracket by
pressing both tabs on the wide end,
then lifting off the bracket.
2.
If the wall plate has a single 2-line or
1-line modular jack,
plug one end of
the supplied 2-line short modular
cord into
L1 OR L1/L2 on the back of
the phone’s base.
Note:
When you make this connec-
tion, do not connect another modu-
lar cord to the
L2 jack. Otherwise,
the phone will not operate properly.
If the wall plate has a single 1-line
modular jack, and there is another
modular telephone jack close by,
plug one end of the supplied 2-line
short modular cord into
L1 OR L1/L2,
and plug the supplied 2-line long
modular cord into
L2.
3. Plug the supplied AC adapter’s bar-
rel plug into the
DC 12V jack on the
back of the phone’s base.
4. Route the AC adapter’s cord
through the right groove on the bot-
tom of the base. Route the short
modular cord through the left groove
on the bottom of the base.
43-689.fm Page 8 Thursday, September 16, 1999 10:22 AM