Filter
Top Products
15
Preparation
2. Press
TALK
so the STATUS/MESSAGE indicator lights and
listen for a dial tone.
3. Press any number other than
0
or
1
.
Note:
If your phone system requires that you dial an
access code (
9
, for example) before you dial an outside
number, do not press the access code either.
If the dial tone stops, you have touch-tone service. If the
dial tone continues, you have pulse service.
4. Place the keypad on the base or press
TALK
.
5. If you have tone service, leave
TONE/PULSE
set to
TONE
. If
you have pulse service, set
TONE-PULSE
to
PULSE
.
Note:
Replace the keypad on the base for 5 seconds after you
set the service type.
STORING YOUR AREA CODE
To dial a number from a Caller ID record (see “Dialing Numbers
from a Caller ID Record” on Page 29), you must first store your
local area code in the phone’s memory. When you dial from a
Caller ID record, the system skips the area code if it matches
the one you stored. Follow these steps to store your area code.
1. Make sure
TALK
is not pressed.
2. Hold down
CHANNEL
for 2 seconds.
AREA
CODE =???
appears.
43-2101.fm Page 15 Wednesday, February 23, 2000 9:12 AM