Filter
Top Products
7
4. Insert the supplied AC adapter’s
barrel plug into the
DC IN 9V
jack on
the back of the base.
5. Route the adapter’s cord through
the strain relief slot on the bracket.
6. Plug the adapter into a standard AC
outlet.
7. Lift the base’s antenna to a vertical
position.
On a Wall Plate
1. Insert the bracket’s tabs into the
base’s lower tab slots, then press
down on the bracket’s clips and in-
sert them into the clip slots.
2. Plug one end of the supplied short
modular cord into the
TEL LINE
jack
on the back of the base.
3. Insert the supplied AC adapter’s
barrel plug into the
DC IN 9V
jack on
the back of the base.
4. Route the adapter’s cord through
the narrow groove on the bottom of
the bracket.
Strain
Relief Slot
Lower
Clip Slots
Tabs
Tab
Slots
Narrow
Groove
43-1104.fm Page 7 Wednesday, August 18, 1999 8:05 AM